Zwave Wireless dimmer Switch, Aeotec WallMote 7, Remote Control/Scene Controller, Battery Powered, Z-Wave hub Required, Z-Wave Plus, illumino

We have an open concept kitchen/living room/dining room, with the light switches for the kitchen and living room combined in the living room, and the dining room (adjacent to kitchen) has its own light switch. I added a 2 gang wall plate and mounted this wireless switch next to the dining room switch and paired it with a zwave physical switch for the kitchen lights located in the living room so that we would have a "3-way" set up with a kitchen switch in the actual kitchen without needing to run wire. It is wonderful for late night kitchen trips as the lights can now be turned on en-route from our bedroom. I wish the mounting plate was molded slightly different as the screws holding the faceplate do protrude and put small holes in the wall (hidden by the plate), but otherwise works as I had hoped.

I am using them with aeotec hub and smartthings. So far working fine. I had 3 zooz ones that worked fine up until a few weeks ago then all 3 stopped working and communicating with aeotec hub. Couldn't find any reason why on internet, so I figured some aeotec update must have prevented the zooz ones from working anymore. Even after removing zooz devices, factory reset and fresh batteries. Too much of coincidence all 3 zooz ones stopped working at same time. I won't be too happy if it turns out aeotec did an update that made the zooz ones incompatible forcing me to buy aeotec remote switches.

Swapped batteries, moved it closer to the hub... it's just a plain poor design.Swapping the batteries is just an accident waiting to happen with the surface mount components there.Not compatible with Alexa, poor support with SmartThings (won't even act as a basic switch without the Edge driver), not compatible with Philips Hue... $50 is an awful lot for this. Keep the box so you can return it!

I have a hallway light that can be difficult to turn on. A while back I installed a smart bulb, but it wasn’t convenient to turn the light on and off with my phone. This switch installed quickly and integrates well with my SmartTings hub.

This switch is identical to Zooz switch except it works. They are clearly manufactured in the same Chinese factory. Easily included into my Hubitat hub. I’m using it to control a Aeotec outlet. Very happy with purchase.

The switch will not remember the settings and you have to push both up and down positions before it will do what it has been programmed to do. Tech support is very poor and documentation is not good.

The device refused to connect to the hub (I have Hubitat). Factory reset (holding the button for 20 seconds) didn't yield anything: the device didn't go into reset mode with blinking white light. Starting inclusion (single tap of any button) doesn't work.

The media could not be loaded.  It may have a small delay of 1s when you interact with the switch, but aside from that, it’s quite easy to setup and looks great on wall.For scene programming, the switch has two button: button up and button down. Each button can be assigned 7 different actions: pressed, held, held down, double pressed, pressed 3 times, 4 times, and 5 times.